Guys, I am working on a mount for a boost and pyro gauge. The boost is the Isspro Enhanced Visibility gauge R6853R. It mounted in a 2 1/16" hole, but I want to know the outer most diameter of the rubber/plastic piece. I am working on an overhead console mount and want to make sure I have the right clearance. If anyone has a gauge laying around or in their truck and could measure it, that would be great.

Thanks
Chris

Chris,
Are you just looking for the outside diameter of the front bezel part (the metal ring which does not fit through the mounting hole) or the actual diameter of the gauge housing (the part which does fit through the mounting hole)? The nominal dimensions are as follows: Bezel - 2.28"; Housing - 2.05".

Regards,
Michael Pliska

Thanks Micheal, the 2.28" dimension is the one I was looking for.

Chris