Ever since i have installed the stacks on my truck they will not smoke evenly. The majority of the smoke will come out the driver side stack which doesnt make much sense to me since it is the furtherst from where the exhaust is split. Is there anyway to get them to smoke evenly?

Make slit in your Y pipe and stick a thin flat piece of steel in the slit and weld it in. Should smoke perfectly even then.

a while back, i fixed a setup on a dodge that would do the same thing. i got rid of the piping in the bed, and used a 4"x6" rectangular tubing. to balance the smoke, i used a small piece of angle iron welded sideways and a little offset on the inlet side to divert the smoke evenly to both sides.


40875