|
LBZrcks 10-10-2004, 11:53 PM Well I've decided to give bully dog's power pup a try since I've heard good things about it. But I already have the Juice/Attitude. So I just wanna use the Juice for its Attitude monitor (gauges) since I don't have my tranny modded yet. But my main question is that do I need to unplug the Juice from my truck when programming with the power pup? or does it not affect the juice box? Jason Got Juice? 10-11-2004, 01:43 AM Jason, you can reflash your PCM without removing the juice, BUT if you have both installed you will be running full timing on both. If it is the hot pup, it will slip the trans on the 155 hp setting. Crawler 10-11-2004, 02:33 AM Dito what GJ said fredw 10-11-2004, 10:02 AM <DIV>power pup limped a buddys truck last week when he was warned and still put it to the 155 setting, he was purty nervous when he called from the side of the road, laughed my ass offhttp://www.dieselplace.com/forum/smileys/hihi.gif</DIV> CYCLONE 10-11-2004, 04:14 PM NOT TO WORRY TRANNY'S ARE AVAIBLE blowinsmoke 10-11-2004, 05:44 PM i read that the edge has no timing?? LBZrcks 10-11-2004, 08:52 PM Ok thanks, it gets annoying unpluging and plugging it back in again. blowinsmoke, I think you are confused on the edge not having timing on LLY's, I believe that the LB7 tune does have timing. hey looked at your sig. got that same HPDI on my boat too. blowinsmoke 10-12-2004, 05:07 PM I love my Yammer, I love racing those short little old guys in race boats, should see their face when I blow past them and then trim up a sick rooster tail,( in a 22' bay boat at that), then I can turn off and blast over some shin deep water as I head back to the dock for more beer! I said that about the timing because I have an LLY. OOPS | ||