Ok I got my injectors and glow plugs out finally. Now I did search this for about 15 minutes but somehow it is hidden:eek: .

Anyhow I want to get the ip off. I do see 3 12 point bolts holding it on. Is there anything that I need to know so I do not mess anything up?

I do have all the lines,intake,wires, out of the way at the back of the pump.:)

thanks joe

The new pump needs to be installed back in the same position as the old one, so mark both the pump and the block. After removal of the old pump, transfer the mark from the old pump to the new one. Upon installation of your new pump, just line up the marks and you are in business.

Thanks for the tip. Anything else other then the 3 bolts holding it in?

Well I started getting this pump off but I did find out there are 3 bolts behind the oil fil tube. Anybody know how to get these bolts out?

Ok I got the ip out finally. 3 bolts inside case (front side of pump)and 3 bolts on the back. Now I can get all my stuff tested and go from there.