hello

I just installed a egdge juice to day. When I try to get a confirm stage, I get very many revs. It revs until I put it in Drive.

Whats wrong?

I have the attitude but no time to install in this or next week.

hallo, enyone??

Plug the attitude in to set the level then shut the truck off and remove the attitude. That way you know what level you're at.

Heck, just run the Attitude wire into the cab through the top of the drivers fender and leave it plugged in. Could even use a bit of tape to keep it from sliding around on the dash until you permanently mount it.

ok, believed something was wrong...


Will do sa...

thanks

Stage 20+ WOOHOO hang on lol

I took my edge out and put it in another truck (we were useing someone elses truck to pick up a horse in GA) I set it on 4 and it worked fine, then set it on 1 for tow/haul. When I checked the settings it worked fine with out tow/haul on when i tryed it in t/h it just set there and reved up and down like you said yours did.. never figured it out thow just went with it.

Just be careful,it wont de-fuel without the pyro hooked up.

hello

I just installed a egdge juice to day. When I try to get a confirm stage, I get very many revs. It revs until I put it in Drive.

Whats wrong?

I have the attitude but no time to install in this or next week.

If you install it without the attitude then you must set manually. With key on and the engine off Put in Drive and press the gas pedal and release for 3 times level 3 then start hitting the tow/haul button to set...It tells you in the instructions how to manually set the edge..Jim

I have the attitude now, work fine!!

Thanks for the reply