|
dirtshredder 04-29-2007, 03:06 PM I am replacing my steering stabilizer and cannot get the old one off. The barrel end of the stabilizer came off fine. The nut came off the rod end of the stabilizer but the bolt doesn't seem to want to budge. Any suggestions? Is the bolt threaded in the steering arm or just corroded bad? SCOTTD 04-29-2007, 08:21 PM Soak it good with WD-40 overnight. Then use a air impact wrench to remove. It'll either come of, or break. (would've broken anyway, probably) As a last resort, there's always the "blue hammer". (torch) :eek: Good luck. This may rank high on the GD Mo-Fo scale!:D Z71offroader 04-29-2007, 10:31 PM get some JB-80 and soak it, and get a cheater bar in there to break it off. time for a bigger wrench! Tuite 04-30-2007, 07:14 AM PB Blaster will work a lot better than WD40, no experiance with JB-80. | ||