Has anyone had any problems where the Hypertech Programmer quits working?? The last time i used it it worked great. I put a 4" exhaust on it and wanted to up the level of performance. I plugged it in the way I always have ( by the book ) turned the key to run and nothing!! dead no lights nothing!! I tried unplugging and plugging in again, looked at the pins and wiring everything looks fine. Just no power to the programmer.

Any ideas??

thanks

Check the fuse in the cigar lighter. If its blown...the Hyper won't work. They use the same fuse.

Should have said "check the fuse for the cigar lighter."

If you're the original owner, I think they have a lifetime warranty on the programmer if it's actually dead..

that was it the fuse was blown!!

thanks for the replies