i have a 2006 GMC and there is this button, that i have no idea what it does. its on the right side ofthe dash, under the vent, next to the back up sensor button. but i dont have back up sensors either. Any one have any guesses on what its used for? my best guess was the roof lights, but i dont have them installed yet, just pre wired from factory.

Does it light up when you push it? I'm guessing its your rear window/heated mirror

Do you have a picture of it, or explain what the pic is on the button? What kind of HVAC do you have?

I bet it is the button that comes with the plow prep package.

Ejection seat?

that light is for your plow beacon you can wire it up to that button therefore you dont half to run a seperate switch, you can access the wireing throught the third brake light

Ejection seat?
:eek:

Does it look like the cab of a cab over truck with a lil light mounted on top? If so its the plow prep button for a blinky light. There is a 30 amp(iirc) relay behind the seat and the wires end in a bundle in the headlinner. You can wire it for anything if you want.

Ejection seat?
Tried pressing that button several times, nagging wife stayed seated. :rippedhan

I need the ejection seat, how much for that mod!! My wife will love it, bye honey!!

i was going to buy a truck that the previous owner had glued a green button that had ejection on it and an arrow pointing to the passenger seat but it was only a fake button

Does it look like the cab of a cab over truck with a lil light mounted on top? If so its the plow prep button for a blinky light. There is a 30 amp(iirc) relay behind the seat and the wires end in a bundle in the headlinner. You can wire it for anything if you want.

Yeah thats what it looks like. Thanks, now when i get one of those lights i have a button for it. Maybe ill make it for the ejection seat, next mod on my truck, haha
thanks again

Yeah thats what it looks like. Thanks, now when i get one of those lights i have a button for it. Maybe ill make it for the ejection seat, next mod on my truck, haha
thanks again

or you can tap into the hot wire comming off the switch and run it to your own relay to use the factory switch to run after market lights...thats what i did

Run a bare hot wire into the passenger seat. Label the button "DO NOT PUSH."

If your truck did not have the plow prep package (and no switch) is the wiring still up in the headliner? Can it be added without a lot of work?

Thanks

I am pretty sure no plow prep package = no wires in headliner..

"Fantasy Button":eek: Hold the button down for 20 seconds and a young "hot-chic" will pop up in the seat next to ya. Here's what ya get:
GMC Trucks: Blonde:D
Chevrolet Trucks:Brunette:D

I am pretty sure no plow prep package = no wires in headliner..
exactly

:funnypost how do i get one

"Fantasy Button":eek: Hold the button down for 20 seconds and a young "hot-chic" will pop up in the seat next to ya. Here's what ya get:
GMC Trucks: Blonde:D
Chevrolet Trucks:Brunette:D

Dang! Should have bought a chevy. I prefer brunettes

i was going to buy a truck that the previous owner had glued a green button that had ejection on it and an arrow pointing to the passenger seat but it was only a fake button

Next thing you know, 007 will drive a Duramax.

"Fantasy Button":eek: Hold the button down for 20 seconds and a young "hot-chic" will pop up in the seat next to ya. Here's what ya get:
GMC Trucks: Blonde:D
Chevrolet Trucks:Brunette:D

Haha, very nice. i think it really works too, cause im picking up a hot blond tomorrow! :D

Haha, very nice. i think it really works too, cause im picking up a hot blond tomorrow! :D

We are going to need pictures to know if it really works.

Have you looked in the owners manual?

We are going to need pictures to know if it really works.
Yeah..... Were serious about that picture part.lol

Yeah..... Were serious about that picture part.lol

X2

:nopics:


Maybe its the GO BABY GO button

Hahaha ok ok ill try to get some good pics, well not TOO good for you guys, but some good pics. :D :D