planning on using the test port on the engine, but need to figure out what type of fitting it uses, and where i can get one..


anyone have any ideas?


i'm tired of removing my bleed screw and dumping fuel all over when i sample http://www.dieselplace.com/forum/smileys/Big Smile.gif

So, where is this test port? http://www.dieselplace.com/forum/smileys/Confused.gif

This is how I took my fuel test sample (http://community.webshots.com/album/83846161wSIlBH) using the Kent-Moore Gauge (http://community.webshots.com/album/73314886FLnSco). I recently modified the gauge by adding a tee and needle valve. This allows an easy way to get fuel samples and/or bleed the system when changing filter. The lift pump (while not necessary) also aids this process.

http://thumb2.webshots.com/s/thumb4/6/56/82/95465682wVUGYc_th.jpg http://thumb0.webshots.com/s/thumb4/6/61/60/95466160coWkql_th.jpg

http://www.dieselplace.com/forum/smileys/Geek.gif