CanadianRigger
03-23-2007, 05:23 PM
Betcha someone can name that part! lol
|
dieselboy28 03-23-2007, 05:30 PM some type of bearing heymccall 03-23-2007, 05:35 PM That's a rimrammer for elderberry seeder, but it's from an early model with relubable muffler bearings:D . Seriously, it looks like the rear pinion support bearing on a 12 bolt chevy rear. jifaire 03-23-2007, 05:41 PM Workin on your front-end, huh? CanadianRigger 03-23-2007, 05:46 PM yea and it aint pretty....... picked up a used one from the wrecker, mines toast, output shaft that goes through that bearing is snapped in two. chrisk1500 03-23-2007, 05:57 PM Love the avatar CR....sounds like Ford is having that problem right now with the new 'strokes.... jifaire 03-23-2007, 05:58 PM Ugh - did it take out the race and seat, too, or did they survive? CanadianRigger 03-23-2007, 06:08 PM i haven't gotten it out yet, i think its fine in there. I just picked up another from the wrecker. When i started to pound out the shaft the bearing decided to come with it....... lol. New one slips in/out by hand. CanadianRigger 03-23-2007, 06:13 PM lol...... cummins musta killed it before i got it, it never had 4x4 when i went to try it. I think maybe the gear vender wasn't dissengaged when it was pulled into 4x. jifaire 03-23-2007, 06:28 PM I remember you talking about the actuator not functioning ... that must have been it, huh? CanadianRigger 03-23-2007, 09:18 PM no, i thought the actuator wasn't working until nick sent me one to try, they both worked fine....... just wasn't anything inside to actuate with that output shaft being sheared. jifaire 03-23-2007, 10:18 PM Not cool, amigo .. but fixable! | ||