recently bought Hi-Five cab clearance lights, will install this weekend. Where do I put the hot wire in the fuse box so the lights come on with headlights?
Thanks in advance

Ron

When i had mine done i had a bunch of ppl on here tell me to route them to the little spot on the dash opposite side of the fuse box in the the same location between teh door n the dash little cover pops off just the like the fuse box. In side there u will find to male end prongs stickin out i just dont remember which is negative or positive but im sure u can test them with a test light but there made to come on with the markers. thats the easy place to run then dont have to worry about fuses or anything like that. do a search on here for cab light wiring n im sure u will find what i did. Later

http://www.dieselplace.com/forum/showthread.php?t=57262 try that see if it works this is my thread when i needed help theres a couple linnks on there.

use a fuse tap from the running lamp fuse in the driver's door jamb fuse box if you do not want to connect to the brown wire from the light switch.

For the 2002's, the +12V can be tapped in Fuse Block-Right I/P, Connector C6, Pin B, which is a BRN wire. This is fused from INT PRK Fuse 10A, located in Fuse Block Left I/P.
The Ground can be connected to this same Connector C6, Pin C, BLK wire.
Connector C6, is a six pin connector, in the opposite corner of C4, which is the larger 12 Pin connector.
Check your out.
Your 2005 may be different.