|
wakeboarder 09-01-2004, 01:37 PM I just got my knew edge box.(old one died) The egt probe is different than the last one. It has stainless steel fittings. After the fitting it has a 90 degree bend in it. Does anyone have a probe like this. I am sure glad I have it back though. If I had to drive it stock after having some juice I would sale it. Max Power 09-01-2004, 01:41 PM I have a probe like that. According to JK it is supposed to be a better probe. Works good for me so far. wakeboarder 09-01-2004, 01:46 PM looks like a better probe any way will w 09-02-2004, 12:10 AM i also have this probe. mine has worked flawlessly so far. wil wakeboarder 09-02-2004, 07:32 AM Got it hooked up last night. What do you guys see at a cold idle? Have not driven it yet but it seem to read different from my other one. will w 09-02-2004, 11:44 PM cold idle after about 30 seconds mine reads between 2-300. wil Crawler 09-02-2004, 11:47 PM All the new Attitudes have that probe. Much improved design. The design is very similar to Pricol etc... baimpala 09-03-2004, 08:09 AM It's been low 70's upper 60's in the morning here when I start up, and after about 30 seconds or so, I am usually around 300-325 when cold. My Attitude reads about 50 degrees higher than my Autometer gauge, the probe is about an inch closer to the engine though, not sure if it would make that much difference there. The probes seem the same to me but the wire on the Autometer is longer (neither cut or spliced during install). Dennis | ||