|
Got Juice? 08-24-2004, 08:31 PM Eric, i am going to be changing the turbo on my truck (again i might add...#4 for the uninitiated) do i need to order a full gasket set from GM or can i reuse the set from turbo#3? The turbo i am removing has appx 7K miles on it. Thanks in advance Juice dmaxalliTech 08-25-2004, 12:14 AM changing the exhaust pedestel (sp) too? Most of the gaskets if not all should be able to be reused. Got Juice? 08-25-2004, 12:33 AM Changing out the stock turbo for another that is "Stock" Will post impressions after this weekend. Since the tranny wars ... i have learned.... if i have time to install it pre dyno i will post the numbers if not... will do it in september! Thank you for the info. The whole turbo pedestal etc will be changed Edited by: Got Juice? Maxter 08-25-2004, 07:00 AM Got juice: What's the difference between your stock and "stock" turbos?http://www.dieselplace.com/forum/smileys/Geek.gif BlueOx03 08-25-2004, 08:18 AM Baaawwhahahahaaaa!!!!!! Dmax Tim 08-25-2004, 08:40 AM His new 'stock' one came off a 600hp cummins http://www.dieselplace.com/forum/smileys/HiHi.gif Got Juice? 08-25-2004, 09:23 AM Got juice: What's the difference between your stock and "stock" turbos?http://www.dieselplace.com/forum/smileys/Geek.gif well, there is stock... and there is "Stock"http://www.dieselplace.com/forum/smileys/Wink.gif Hired Gun 08-25-2004, 09:24 AM Well now it will fall apart!http://www.dieselplace.com/forum/smileys/HiHi.gif Just Kidding!http://www.dieselplace.com/forum/smileys/Clap.gif Got Juice? 08-25-2004, 09:38 AM Well now it will fall apart!http://www.dieselplace.com/forum/smileys/HiHi.gif Just Kidding!http://www.dieselplace.com/forum/smileys/Clap.gif Nahhhh, gonna leave the juicegrips at home this timehttp://www.dieselplace.com/forum/smileys/HiHi.gif There is nothing wrong with #3. 7500 miles and always shut down at 350F... just changeing it out 'because it's there'http://www.dieselplace.com/forum/smileys/Rock On.gif I do need to know the book rate for changing one out.... AKA how much beer this is worthhttp://www.dieselplace.com/forum/smileys/Big Smile.gif dmaxalliTech 08-25-2004, 11:13 AM warranty time is only about 4 hours to change it. If you can do it that fast, your hired Kennedy 08-25-2004, 11:18 AM When you are done, you can come over and install mine! I hate to even think about pulling the pedestal. Cartridge change is POC, but the pedestal... Some day I'll do it along with a manifold/feed pipe swap... Got Juice? 08-25-2004, 11:41 AM When you are done, you can come over and install mine! I hate to even think about pulling the pedestal. Cartridge change is POC, but the pedestal... Some day I'll do it along with a manifold/feed pipe swap... And do it in 4 hours????? aaaaaaaaaaaaaa! we will see... dyno day is this weekend, and i pick it up at the event.... hopefully git r done before i spin the rollers! Spinny things Rock! Got Juice? 08-25-2004, 12:07 PM I bought the whole turbo, pedestal and all.... my 50.00 Ebay specialhttp://www.dieselplace.com/forum/smileys/Big Smile.gif then had it reworked!.. am i further ahead to replace everything incliding the pedestal or just the turbo? Stock VS "Stock" Quotes means Super Stockhttp://www.dieselplace.com/forum/smileys/Rock On.gifEdited by: Got Juice? | ||