I wasnt aware of the fact that most of the pillar mounts for the attitude go over top of the stock pillar. Are there any that replace the whole pillar? Thanks The one I was looking at is from DPP.

I had an attitude pillar in my truck and yes, it installed over the stock pillar, but it covered the entire pillar and I didn't use any push pins or screws to hold it in place other than it fit really, really tight against the stocker. I ran the wire down the inside of it so the stock pillar wasn't damaged at all. Got it from DPPI. Autometer I think.

I'm not aware of any full replacement pillars for either gauges or Attitude monitors.

Huh, I always assumed they replaced the pillar, thanks guys.

I remember several on the forum who used the Autometer full pillar pod WITHOUT speaker hole, as a replacement. They cut out the hole for the speaker, using the factory a-pillar hole as a template, and transferred the speaker over to the Autometer pod.

lovette,

We have them with and without the speaker hole at the same price so you don't have to cut it yourself if you don't want to.
Matching color paints as well.

Mark @ DPPI