I assumed there was one in the how to section but I could not find it in that section or by search. I am looking for a detailed how to on the pyro install and plumbing the attitude throught into the cab. If someone could post a link I would appreciate it. Thanks

Well it's a little tough to find since it's labeled thermocouple install rather than maybe EGT:


http://dieselplace.com/forum/forum_posts.asp?TID=946&PN=2


That's just the probe, running the wires through the firewall is not illustrated, but there are several options depending on what you want to do and where you mount the Attitude.


There's a fuse panel/terminal block under the dash where you hook up the brake controllers and so forth. Right above that is a rather large two piece rubber grommet that I used to get the Attitude cable through. You'll need to remove the cover, then that panel to get to it. The panel is just held on with plastic/nylon type standoff clips, once the cover is off, you'll be able to see how it's held on.


Have fun...http://www.dieselplace.com/forum/smileys/Approve.gif