|
Turbine Doc 07-21-2004, 10:29 PM Someone over at TD Page needed a photo of IP turning tools I got mine from Snap On probably something you can make at home. PN is J-29872-A K-M USA 7 2 http://www.dieselplace.com/forum/uploads/A1B_DCP00446.JPG http://www.dieselplace.com/forum/uploads/5C6_DCP00447.JPG Turbine Doc 01-10-2006, 03:22 PM Tool dimensions in this thread thanks Goldsburg for searching & finding it http://www.dieselplace.com/forum/showthread.php?t=44749&page=2&highlight=pump+tool Turbine Doc 01-10-2006, 03:25 PM Bumped back to top for info refresher also can be found in FAQ minisub 01-10-2006, 05:17 PM Tool dimensions in this thread thanks Goldsburg for searching & finding it http://www.dieselplace.com/forum/showthread.php?t=44749&page=2&highlight=pump+tool Hmm, I they way I was reading the messages at start up this week, I thought links with the "the" at the beginning of the url wouldn't work anymore. That one is fine for me. Turbine Doc 01-10-2006, 06:10 PM I think it's still working on the older posts where this came from | ||