I need to relocate/remove the rear AC controls in my 2003 Yukon. I'm going to install a DVD monotor in the headliner. I'd like to move the controls, but I might just remove for now, since I'll have to splice 14 wires to relocate.


My question is: when the rear controls are unplugged, the rear AC won't work at all. What do I have to do to make it work without the rear controls. I imagine it should be just a few jumper wires, but which ones???


Thanks for the help, I know it's not a diesel question, but you guys are the most helpful I've found around!!!


Josh


2003 CC D/A, Edge Attitude, 4" Exhaust, K&N FIPK, 285 A/Ts

The factory had a setup for it as they are offered with it........


I for one would get a HELMS manual.............


You may be voiding the warranty by removing it...........


I would do a lot of asking before any cutting..........


Good Luck,





Thttp://www.dieselplace.com/forum/smileys/Clown.gifNY