I'm looking for a good place to tap the horn switch without getting into the steering column.


This is to wire up some air horns. The horns are intended to be wire in parallel with the vehicle's stock air horns and have their own relay (which I already know where I'm going to get power for the relay).


I also would like to know if tapping the stock circuit will drag it down too much to activate two relays (I would think it would be okay, but don't want to screw it up).


Thanks,
Dennis

Black with a yellow stripe under the steering column. It will test ground when you push the horn. Check with a DMM. No problem hooking two or even 10 relays up to it.

Max Power,


Thanks, you are the man. I knew that you would answer this one for me. Seems like you haven't been on much the past couple days. . .


Thanks again,
Dennis

Lots on the go. http://dieselplace.com/forum/smileys/Big%20Smile.gif