I Have A Ppe +2 Hot Tuner And Was Wondering If I Can Stack An Edge With Attitude Programmer With This, Besides The Given Trans Slip Problems, What Mods Do I Need To Run These 2 Together If Any. Any Help Would Be Apprieciated Thanks.

You can do it without anymore mods if you choose to. The only thing i have been worried about with "stacking" is having too much timing but im not sure if you can adjust those things with your ppe.

I have stacked with both the Edge and also the Va Smartbox........currently running the stack with the Va......No tuner stacks very well with the Edge, the VA is very nice though.

i used to have a simular stack untill i went to efi. i all ways was pulling 1093's lift pumps and the fuel pickup helped that out.

Im running Ppe and edge with attitude works great. I acually had to do this to get rid of the "Service Brake System" Warning from the DIC because of my 4.63 gears I have. I havent seen the message since the double stack

And U Dont Have Any Other Problems With To Much Timing Or Anything? It Runs Fine? Is Ur Trans Stock Or Built What Level Do U Have Ur Ppe Set Too?

And U Dont Have Any Other Problems With To Much Timing Or Anything? It Runs Fine? Is Ur Trans Stock Or Built What Level Do U Have Ur Ppe Set Too?

i ran just an edge no attitude stacked with my PPE Hot +2 ET and went slower on level 3. 3/10's slower.

And U Dont Have Any Other Problems With To Much Timing Or Anything? It Runs Fine? Is Ur Trans Stock Or Built What Level Do U Have Ur Ppe Set Too?
Your trans needs to be beefed up to handle power in excess of 100hp or more over stock.

I'm running my Edge/Attitude with an updated PPE programmer right now.

With the new PPE you can modify the programs to add timing...or not. This is supposed to allow you to stack it with a harness box.

I've been running it for a couple of weeks and I'm not sure if I like it or not.

The PPE by itself is great. Lots of power and runs fairly smooth.

The Edge by itself is great. Smooth, no codes just not quite enough power.

But when I stack them, even with the low timing PPE tunes, they just don't work as well together as I had hoped. P0101 and P0299 codes and not as much power as the PPE programs by themselves.

I haven't had that much time to play around with it though. There may still be a good combination with them.

I have been running the ppe hot +2 stacked with the ppe enforcer 175 plug and play and have had no problems with them. The hot +2 is awesome by itself, but u can tell when both of them are on also.