Quick question,I just purchased the 3500 rear id lamp(from gmdieseltech), and I noticed that it is beveled.Question is does the bevel go on the top or the bottom,as it matters where You have to drill the holes.Thank's Rob.http://www.dieselplace.com/forum/smileys/Cool.gif

Top





Mac

Thank's Mac.http://www.dieselplace.com/forum/smileys/Cool.gifhttp://www.dieselplace.com/forum/smileys/Thumbs Up.gif

CT Rob,


i bought the same i.d. lamp with all the factory fasteners and supposedly the same factory harness as a 3500.i can't figure out where the harness plugs in or if i need a different harness so i don't have to splice in to the factory wiring.also,if you could pass on how you drilled that panel under the tailgate to fit the lamp,it would be much appriciated.thanks. http://dieselplace.com/forum/smileys/Rock%20On.gif

I posted instructions. Hopefully it will get moved to usefull articles.

Thanks smshiver.


Do you know where that post is?

http://dieselplace.com/forum/forum_posts.asp?TID=12841

Thank You Max Power and smshiver.I will give it a shot and let you know how i make out.also,what measurements did you use to drill?i tried to find a dually to measure the light,but haven't seen one around.thanks again.