|
: wire through firewall LBZ HELP!!!! carcrafter22 10-04-2006, 01:07 PM Hello all I need to know how you all ran your egt and boost wires through the firewall on the 06 LBZ trucks I HAVE SEARCHED for two days and all I can find are pics of the install on older trucks and they are different than my truck thanks for any help pics would be best THANKS again for all the help Randy Vege-Taco 10-04-2006, 06:21 PM Follow the throttle wires up and left and you will find a HUGE grommet you can slit and run wires through. It comes out just below the brake resevoir. Ruben Z 10-04-2006, 08:07 PM I agree, everyone said that the best place is to the top right of the gas pedal, but my 06' and 07classic have a bunch of plastic there. So I'm confused as well. I'm tempted to make another 2" hold in the firewall and put a huge Grommet there just for accessory stuff lol. Vege-Taco 10-04-2006, 09:37 PM I agree, everyone said that the best place is to the top right of the gas pedal, but my 06' and 07classic have a bunch of plastic there. So I'm confused as well. I'm tempted to make another 2" hold in the firewall and put a huge Grommet there just for accessory stuff lol. It's up and LEFT. Behind the fuse box area. carcrafter22 10-04-2006, 10:01 PM thanks guys I finished the gauge install today and will have pics up tomorrow. I ran my wires through the grommet by the throttle wires the EGT wire barely stretched and I had to add some more tubing to the boost gauge thanks again Randy Ruben Z 10-05-2006, 12:33 AM It's up and LEFT. Behind the fuse box area. Shawn, do you think you could get a pic of that for me. Cuz honestly I was struggling big time trying to wire stuff through the factory harness grommet, to the point where when I stuck the close hanger through there I stripped off the tape in the inside exposing the wires, I was ****ting bricks, luckily I didnt scrape through the wires themselves but just the electrical tape. Vege-Taco 10-05-2006, 09:20 AM Here are some pictures. Two from inside the cab and two from under the hood. Shawn AZMAX 10-05-2006, 10:12 AM I drilled a whole where the slave cylinder would go if you had a manual. It is already center punched and has a plastic cap over where it would go on the inside. I will see if I can take some pics later. It seems to be in the same location that SSonnentag's was already grommeted. | ||