Hey guys,


I was thinking about putting a 6" suspension lift on my 2500HD w/ 35's. I was wondering if you can change gear ratio's? I had a '04 silverado with a 4" suspension and I put 4:56's in it but I didnt know with the Allison tranny and all.





Thanks,


Chad

There have been some guys on here that did it.....VooDoo comes to mind. No one seems to have any problems with it as of now....


HD

I run a 6" Superlift with 315/75/16 BFG's and stock gearing. I have added a 4" exhaust, Predator programmer, gauges, etc., and have no problem with the performance. Truck was very drivable even before the power mod's. Unless you plan on going larger than 315's (35" tires), I see no need to re-gear. By the time you change front & rear gears, you could have added a few power mod's and put the difference in $$$ in your pocket. Good Luck, DinoMaxhttp://www.dieselplace.com/forum/smileys/Big Smile.gif http://www.dieselplace.com/forum/smileys/Big Smile.gif

I have 315/75/16 Goodyear MTR's and I put 4:10 gears in to get my performance back. It cost me about $2000 for front and rear gears installed. I have not had an issue at all.