Diesel Place banner

Trim pieces on my LMM are not straight!

746 views 4 replies 3 participants last post by  Bigred118 
#1 · (Edited)
I was looking close at my truck and I noticed that the passenger door trim is not straight. It is about 1/4" to 3/8" higher at the front than the back. The 3500 follows the trim as well as the allison logo. My question is this, are the just stuck on with a tape type product or are there alignment holes behind these items? I think that I am going to call my dealer and have them look at it but wanted your guys opinions first. I know that I am anal but it has been bugging me for the last 24 hrs.
 
#2 ·
Just double sided tape, no holes:)
 
#4 ·
Is this something that the dealer will warranty?
 
#5 ·
Dealer is going to warranty it. The difference was 2" from the rear of the rear door to the front of the front door. Hope this isn't a Friday truck
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top