 |
|
 |
 |
        |
 |
|
|||||||
| Register | FAQ | Forum Rules | Calendar | My Replies | My Threads | Mark Forums Read | Auto Escrow | Auto Loans |
 |
|
|
LinkBack | Thread Tools |
11-19-2012, 07:27 PM
|
#1 (permalink) |
|
Diesel Master
Join Date: Aug 2011
Location: Wahnapitae, Ontario, Canada
Posts: 1,103
iTrader Score: 0 reviews
|
gm td scan tech basic obd2?
is there a way to hook up the gm td scan tech basic to use it on obd2? any idea hows its done if possible?
__________________
1994 GMC 1500 HD Z71 4x4 ext cab 6.5L TD,3.73 GEAR RATIO LIMITED SLIP POSITRACTION  ,4L80-E 4-SPD Lubrication Specialists oil lines,Transmission lines replaced with Hydraulic lines,pmd mounted on heat sink in bumper home made wiring harness all soldered greased and shrink tubed,gutted intake,tcc mod,380000kmsegr blocked off with intake gaskets,New heads May 2012,ARP head studs,2 1/2" cross over 3" down pipe 4" straight pipe  1998 k2500 Z71 ext cab 6.5 TD,stock exhaust,muffler delete soot trap gutted,4:10 gears,grey standyne pmd in front bumper,312000km,Lubrication Specialists oil lines,trannytemp,boost,EGT,fuel pressure gauges |
| Offline |
Tweet
-->
|
| Sponsored Links | |||
Advertisement | |||
|
11-19-2012, 08:23 PM
|
#2 (permalink) |
|
Diesel Laureate
Join Date: Feb 2006
Location: Richardson, TX
Posts: 10,304
iTrader Score: 0 reviews
|
No, only OBD-I.
The standard is different.
__________________
1995 GMC Suburban: PMD in Bumper 4" Warpspeed Exhaust
KD LP/OPS Harness Bosch Duraterm GP Heath Turbo-Master Chevron's XLP Diesel Additive Last edited by JMJNet; 11-19-2012 at 08:23 PM. |
| Offline |
|
|
11-19-2012, 09:04 PM
|
#3 (permalink) |
|
6.5TD Post Addict
 
Join Date: Jul 2010
Location: Scugog Island Ontario Canada
Posts: 7,763
iTrader Score: 0 reviews
Ontario Diesel Place Chapter Member Old School Oil Burners (Old SOBs) Member |
Carcode or Auto Enginuity are the OBDII windows scan tools for our trucks.
Snap on red brick mt 2500's do work not too bad for OBDII and can be had reasonable on ebay. They won't do TDCO relearn but they will display the stored value and KOKO can initiate the relearn.
__________________
96 Chevy C3500 Dually 6.5TD F Engine 4.11 Rear/5 Speed Relocated PMD/Heatsink to Front Bumper #9 Resistor K-47 Standard Duty AC Air Filter And K-47 Housing Kennedy special calibration fan clutch/Kennedy 20" steel fan PMD Cable oil cooler kit Diamond Eye 4" turbo back exhaust 2 1/2" crossover High Idle Mod Feed The Beast 2.0 EGT,Boost gauges Diagnostic Checklist 2.0 OBD1 Codes OBD2 Codes 6.5 FAQ Carcode & TDCO Instructions |
| Offline |
|
|
11-19-2012, 09:18 PM
|
#4 (permalink) |
|
Diesel Master
Join Date: Aug 2011
Location: Wahnapitae, Ontario, Canada
Posts: 1,103
iTrader Score: 0 reviews
|
its wasent for our trucks actually was wondering if i could use it on my car to read codes and all different values
__________________
1994 GMC 1500 HD Z71 4x4 ext cab 6.5L TD,3.73 GEAR RATIO LIMITED SLIP POSITRACTION ,4L80-E 4-SPD Lubrication Specialists oil lines,Transmission lines replaced with Hydraulic lines,pmd mounted on heat sink in bumper home made wiring harness all soldered greased and shrink tubed,gutted intake,tcc mod,380000kmsegr blocked off with intake gaskets,New heads May 2012,ARP head studs,2 1/2" cross over 3" down pipe 4" straight pipe 1998 k2500 Z71 ext cab 6.5 TD,stock exhaust,muffler delete soot trap gutted,4:10 gears,grey standyne pmd in front bumper,312000km,Lubrication Specialists oil lines,trannytemp,boost,EGT,fuel pressure gauges |
| Offline |
|
|
11-19-2012, 09:19 PM
|
#5 (permalink) |
|
Diesel Master
Join Date: Aug 2011
Location: Wahnapitae, Ontario, Canada
Posts: 1,103
iTrader Score: 0 reviews
|
thanks for the info thought!!!
__________________
1994 GMC 1500 HD Z71 4x4 ext cab 6.5L TD,3.73 GEAR RATIO LIMITED SLIP POSITRACTION ,4L80-E 4-SPD Lubrication Specialists oil lines,Transmission lines replaced with Hydraulic lines,pmd mounted on heat sink in bumper home made wiring harness all soldered greased and shrink tubed,gutted intake,tcc mod,380000kmsegr blocked off with intake gaskets,New heads May 2012,ARP head studs,2 1/2" cross over 3" down pipe 4" straight pipe 1998 k2500 Z71 ext cab 6.5 TD,stock exhaust,muffler delete soot trap gutted,4:10 gears,grey standyne pmd in front bumper,312000km,Lubrication Specialists oil lines,trannytemp,boost,EGT,fuel pressure gauges |
| Offline |
|
|
11-19-2012, 09:25 PM
|
#6 (permalink) |
|
6.5TD Post Addict
Join Date: Jul 2010
Location: Scugog Island Ontario Canada
Posts: 7,763
iTrader Score: 0 reviews
Ontario Diesel Place Chapter Member Old School Oil Burners (Old SOBs) Member |
I would get a snap on mt 2500 for your purposes,I have 2 myself but that is cause 1 died.
Many are available on ebay and come with many cartridges and other needed hardware. They are OBD1 and OBDII when properly equipped but support stops at 2008 I believe.
__________________
96 Chevy C3500 Dually 6.5TD F Engine 4.11 Rear/5 Speed Relocated PMD/Heatsink to Front Bumper #9 Resistor K-47 Standard Duty AC Air Filter And K-47 Housing Kennedy special calibration fan clutch/Kennedy 20" steel fan PMD Cable oil cooler kit Diamond Eye 4" turbo back exhaust 2 1/2" crossover High Idle Mod Feed The Beast 2.0 EGT,Boost gauges Diagnostic Checklist 2.0 OBD1 Codes OBD2 Codes 6.5 FAQ Carcode & TDCO Instructions Last edited by racer55; 11-19-2012 at 09:27 PM. |
| Offline |
|
|
11-20-2012, 08:25 AM
|
#7 (permalink) |
|
Diesel Laureate
Join Date: Feb 2006
Location: Richardson, TX
Posts: 10,304
iTrader Score: 0 reviews
|
For cars, etc.
There are a lot of choices. You can also get an ELM based scanner that hook up to a computer similar to GMTDScan. The fanciest one ELM based is using wifi or bluetooth so you won't need any cable at all. Well, you have to still buy some sort of interface.
__________________
1995 GMC Suburban: PMD in Bumper 4" Warpspeed Exhaust
KD LP/OPS Harness Bosch Duraterm GP Heath Turbo-Master Chevron's XLP Diesel Additive |
| Offline |
|
|
11-20-2012, 10:32 AM
|
#8 (permalink) |
|
Diesel Head
Join Date: Sep 2012
Location: New York, NY
Posts: 26
iTrader Score: 0 reviews
|
I have the Elm (Chinese bluetooth module off Amazon) that I bought for about $13. I also bought the "Torque" app for my Android phone to go with it for the astronomical price of $5. The combo works great on my '96. Basic functions, real-time monitoring, logging, DTC/CEL reading/logging/clearing, etc. Can't beat it IMO.
|
| Offline |
|
|
11-20-2012, 11:27 AM
|
#9 (permalink) |
|
Diesel Specialist
Join Date: Aug 2009
Location: Stillwater, Minnesota
Posts: 592
iTrader Score: 0 reviews
Minnesota/Western Wisconsin DP Club Member |
I have and ELM 127 bluetooth for my 2000 Mercedes Wagon and downloaded the FREE Torque app to my phone. It can check and clear codes and give me live data. That is fine for my application so no need for me to spend money on the pay version of Torque. IIRC I purchased my ELM 127 bluetooth of eBay for about $16 delivered to my door. Had it almost a year and no issues so far.
(I have GMTD Scan Tech for my 94 6.5)
__________________
Ryan 1994 Chev Suburban K2500 6.5 230k miles -LubSpec Oil Cooler Kit -Webasto Diesel Coolant Heater w/Remote Start -Remote PMD on Heat Sync in bumper -Newer IP, New Bosch Injectors, New Bosch Duraterm Glow Plugs, Newer Radiator -PYO Aluminum Wheels -Boost, Fuel Pressure, EGT Gauges -Rebuilt Transmission @ 227k miles -LP Relay Mod, High Idle Switch Mod, Glow Plug Override Mod -New OPS, Batteries, Brakes, Starter, Alternator, Fuel Lines, Lift Pump -GMTD Scan Tech -599 Block from the factory |
| Offline |
|
|
11-22-2012, 05:42 PM
|
#10 (permalink) | |
|
Diesel Enthusiast
Join Date: Nov 2010
Location: Omaha
Posts: 21
iTrader Score: 0 reviews
|
Quote:
__________________
Everything I know about 6.5's came from this site!!! Thank you!!! 97 K2500 LT Suburban 6.5TD 240K 285/75/16 Dick Cepeks on 2007 Duramax aluminum wheels, 5 in exhaust, K/N, 480LE, 4.10's, new harmonic balancer, Pensicola PMD, Turbo-master, boost-fooler and vac pump delete with 99.5 in belt!!! |
|
| Offline |
|
| Sponsored Links | |
Advertisement | |
| Sponsored Links | |
Advertisement |
|
|
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OBD2 Scan tool question | vietvet66-67 | Shop Talk | 3 | 02-22-2012 03:28 PM |
| Basic Scan Tool Recommendations? | dougydeezel | 6.5L Diesel Engine | 6 | 06-28-2011 02:18 PM |
| OBD2 scan tools | dropdprpls10 | First Generation Duramax Electronics/Tuners | 9 | 05-25-2011 12:55 PM |
| GMTD Scan Basic Help | primo382 | 6.5L Diesel Engine | 7 | 10-31-2009 05:06 PM |
| Obd2 Scan Tool | kittysniper454 | 6.5L Diesel Engine | 4 | 12-29-2008 08:38 PM |
