I have an 06 LBZ with a built motor that is bore 20 over with a fleece 68mm with a wicked diesel cp3 upgrade and 45 over injector nozzles and Idaho robs tune. Every time I start it up it blows a puff of white smoke and if I leave it in a higher tune the worse the smoke is. Is this bad, alright, or normal? Any help would be apprecited. Thanks in advance
i catch mine letting out a whitish haze while its idleing every now and then and its basicly stock. but i have seen a few dmaxes that billow white smoke when they idle not sure what the cause of it is
Your Dilithium crystals in the warp drive (right on top of the intake - has a pipe that runs down the back of the motor out the back of the truck) are out of alignment. Multiply the angle of the dangle by PI cubed and divide by the transient of beta quadrupled and you will have the correct alignment.
i.e. - Everything is fine ******.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Diesel Place
5.3M posts
218.8K members
Since 2003
A forum community dedicated to Chevrolet and GMC diesel truck owners and enthusiasts. Come join the discussion about duramax engines, performance, builds, modifications, classifieds, troubleshooting, maintenance, and more!